I'm trying to finish my front end, 74 cj dana 30 w/ chevy disc conversion. The manual says to tighten the first spindle nut until it binds, can...
I'll check the hubs. I bet I didn't have enough machined of the back of the hubs. I just took enough to make them flat. Thx guys.
Yes it is off on the backside of the disc and I have a gap on the front side. It is so tight on the back that I cant even slide the pad into place.
I figured that it was a dust shield. Went back and took it all apart a double checked the inner race just to make sure it was the right one,...
mine doesn't have the circle on it. Is it possible that i have the wrong one? 2wd version maybe?
I can't seem to find any good pictures of the caliper brackets used for the conversion using chevy parts. I got everything put together using the...
Just a fyi, I ordered the Moog ball joints. Got them from rock auto for $25.99 and $29.99 a piece, so not too bad. Thanks to everyone for the...
Appreciate all the responses, now does anybody have a good place to buy them? Thanks again. Sent from my SAMSUNG-SGH-I727 using Tapatalk 2
OK I'm at the point where I have to buy ball joints and I will be able to finish the front end rebuild. Does anybody recommend a certain brand? Is...
When I read that I was thinking "dang these things must be fragile to be so thick" but then again I'm not a mechanic either. Haha Sent from my...
I did a search and read lots of the threads. Don't have the links or I would post them. Sent from my SAMSUNG-SGH-I727 using Tapatalk 2
Thank you, that's what I needed to know. I will check it to make sure it isn't warped. Sent from my SAMSUNG-SGH-I727 using Tapatalk 2
Separate names with a comma.