I ran into that issue as well, I ended up clocking the distributor to maintain clearance with the fan. Just be careful when clocking, because its...
I went through this as well. It was the most frustrating thing ever. Had the Trans out like 20 times. I have a 225 v6 (With heavy flywheel) mated...
Bring some extra tie rod ends.... I did not bring any spares and was on the top of a mountain, a tie rod end popped, and I had a very interesting...
Question for you guys, How do you tell how tight the nut on the outside should be? I think mine is too loose, but im not sure. Thank you,...
Thanks Guys! -Eric
Hey Guys, I am rebuilding my Dana 18. I was wondering which direction the speedometer drive gear goes? Does side A go towards the transfer case?...
Thanks for letting me know. Do you think I should rebuild the entire case again? or just get a new shaft? Thanks -Eric
Hey, Thanks for replying, The kit was purchased from Parts Mike. The shaft replacement was included in the kit. I replaced everything in the...
Hey Guys, I have a question... I have a 1 1/4" shaft Dana 18. I rebuilt it, and after about 1200 miles it was howling soo bad that I took it...
I used a 3 core aluminum rad from championradiators.com. model CC435 I believe. It fit great in my 42 MB with 225 v6. Here is a pic the rad....
Those hangers are super cool. If you dont want to build any more, would you want to share the plans? ;)
I dont know if its normal or not, but the same thing happened to me. I checked the whole system for air leaks then disconnected the fuel line at...
I would just take off the drive shafts. But if you dont, put it in gear so it lubes itself as it goes. Also, there are a ton of threads on...
Separate names with a comma.