1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

timgr's Recent Activity

  1. timgr replied to the thread Salvage Yard Engine Preparation.

    Put the ring in the bore and measure the gap with a feeler gause. Should be fine in modern times, but it's something you do anyway....

    Jan 25, 2025 at 12:58 PM

  2. timgr replied to the thread Jeep Vs Ford T18.

    This is the 1982 J20 T-18 along with the NP208 transfer case. [IMG] I believe the transfer case adapter design is shared with 4WD Ford...

    Jan 25, 2025 at 11:47 AM

  3. timgr replied to the thread Jeep Vs Ford T18.

    Yes, understood. My J20 retains that configuration from the earlier FSJs. From 1980 on, the wagons and trucks dropped on the driver's...

    Jan 25, 2025 at 10:56 AM

  4. timgr attached a file to the thread Jeep Vs Ford T18.

    This is my J20 transmission on the bench. [ATTACH] The yellow arrow is the bolt that changes from Ford for the Jeep case. I suspect...

    J20transWithArrows.jpg Jan 25, 2025 at 10:46 AM

  5. timgr replied to the thread Jeep Vs Ford T18.

    Usual problem with the 2-3 shift is clipping reverse. Much of that problem comes from a broken/collapsed limit spring in the shift top....

    Jan 25, 2025 at 10:29 AM

  6. timgr attached a file to the thread Fuel Gauge Wiring..

    My apologies to Howard, but I think the generator diagram leaves something to be desired. This is from the '72 TSM. Should be the same...

    Jeep72ChargingDiagram (922 x 560).jpg Jan 25, 2025 at 9:53 AM

  7. timgr liked sterlclan's post in the thread Fuel Gauge Wiring..

    without the alt light hooked to the three wire type alternator the charging will be sluggish may not charge at an idle.

    Jan 25, 2025 at 9:37 AM

  8. timgr replied to the thread Fuel Gauge Wiring..

    Any alternator uses its own output to power its field (rotor) and make three-phase current when the rotor spins. Current from the...

    Jan 25, 2025 at 9:37 AM

  9. timgr replied to the thread T-18 Four-speed Factory Floor Covers.

    More than one yellow. I think there was Mellow Yellow (darker) and maybe Daisy Yellow (lighter). There was also Transport Yellow (a...

    Jan 24, 2025 at 8:38 PM

  10. timgr replied to the thread T-18 Four-speed Factory Floor Covers.

    Heh. Sorry I did not keep your name with the pictures. Thanks for posting the originals. I'm right about the year - am I right about...

    Jan 24, 2025 at 6:18 PM

  11. timgr liked HeavyIron's post in the thread T-18 Four-speed Factory Floor Covers.

    Hey!! I recognize that Jeep! I can take more if needed.

    Jan 24, 2025 at 6:18 PM

  12. timgr replied to the thread Junkyard Project - Part 2.

    That's cool. Brian did a lot of this kind of stuff because he could and I presume for the coverage in the automotive press. Just to...

    Jan 24, 2025 at 11:51 AM

  13. timgr liked Jeepenstein's post in the thread Junkyard Project - Part 2.

    [ATTACH] [ATTACH] [ATTACH]

    swap1.jpg swap2.jpg swap3.jpg Jan 24, 2025 at 11:38 AM

  14. timgr replied to the thread What Parts Are Realy Hard To Get For An Intermediate Cj.

    A '72 V8 Wagoneer would have gotten the T-15 as the standard transmission. However, the T-15 for a V8 Wagoneer is different from the CJ,...

    Jan 23, 2025 at 9:38 PM

  15. timgr replied to the thread WTB Dana 44 Power Loc.

    I would say it's either an earlier coarse-spline (10?) unit for the tapered axles, or swapped in. AFAIK the 30 spline Wagoneer got the...

    Jan 23, 2025 at 4:17 PM
Show older items
New Posts