Here's another similar write-up. If the link doesn't take you to page 6 of the thread skip to that ......
So is there a measurement that I can take to insure I have the correct case for a lower gear set? The new ring gear I bought is definitely...
Can someone explain how to tell the difference in carriers? I recently bought one and was told it was for the lower ratios. But when I set it...
I tried disconnecting the rear driveshaft and running through the gears. It seems like if there isn't a load on the transmission it does okay....
If the "mainshaft rollers" are the bearings on the front of the transmission then yes I was careful to insure those were there properly. Many...
Nope, transmission did not get taken apart. I disconnected it from the t-case but I did not disassemble it.
I went out and checked the forks. They are in the correct grooves. There is some wear on the back of the forks but it doesn't looks too severe....
I have driven the jeep. Just up and down the alley and around the block but I am able to go through all 3 gears. When driving I can upshift but...
Okay, I need some help/advice/suggestions. I finally got my jeep up and running after several years in the garage. Unfortunately I am now having...
I recently found another L-head to replace the one in my jeep. As I started looking at it I noticed some differences in the oil lines to the...
I thought I might try to drive out there and take a look sometime in the next few days.
Is this sitting on 377 in Collinsville?
...so where is this $3500 jeep located?
Separate names with a comma.