Yup! dang throttle plate shaft was leaking bad on mine. I took him apart machined a couple of o ring grooves on the end of the shaft. Ran for...
Had one like that on a 1980 Datsun pickup.
Nothing that I can see. Pretty crafty IMHO. I've had good luck with Kroil as a penetrating oil.
I have an older Sears engine analyzer I use to set the dwell and to check points resistance. Get dwell right and the gap may not be right anyway...
I've never delt with a Pertronix but I know I've been told since I was a kid not to touch points with a metalic feeler gauge so as not to damage them.
"There's no noticeable smoke but it does smell a bit like unburned gas" Sounds like a carb issue to me. If it sat over the winter the fuel...
Swap over to a 225.
I had the same problem with my 225 in my cj5. It turned out it had a clogged tube in the carb. Left side was just dumping fuel.
Does any one have the NAPA part number for a float in a 2gc?
I picked up a 225, it has the Headman headers on it like above. I would like to put them on my 225 I currently have in my Jeep. How much is...
I am going to stick with the 225. I found another 225 close to me. Going to go pick it up this weekend. Should be a fun project. Hopefuly I'll...
Separate names with a comma.