1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

What should I use

Discussion in 'Early CJ5 and CJ6 Tech' started by smiggley, Nov 10, 2010.

  1. smiggley

    smiggley Member

    Just got around to installing my new axles. I put a dana 30 to replace my old worn out dana 27. I need to change the front driveshaft end to fit the dana 30. Im going to do the welding myself but Im having a hard time locating an end to weld to the existing shaft. Any suggestions? Thanks ahead of time.
     
    smiggley, Nov 10, 2010
    #1
  2. dnb71R2

    dnb71R2 SuperDave 2023 Sponsor

    You can change the yoke on your transfer case to a Dana 20 type, and then you can use standard CJ type U-joints. This will require a complete front drive shaft replacement, though. This change also allows you to use the same U-joints on both drive shafts.
     
    dnb71R2, Nov 10, 2010
    #2
  3. mortten

    mortten I can’t put my finger on it 2024 Sponsor 2023 Sponsor 2022 Sponsor

    If you have V-6 it runs smaller joints. You can put a 4 cyl yoke on the output of the transfer case and use a 4 cyl shaft. Then you have the large joints at both ends. That's what I did with no clearance problems.
     
    mortten, Nov 10, 2010
    #3
  4. Smokeater

    Smokeater Sponsor

    ^^x2
     
    Smokeater, Nov 10, 2010
    #4