1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

T15 Transmission/transfer Case Mount

Discussion in 'Intermediate CJ-5/6/7/8' started by rusty72cj5, Jan 16, 2020.

  1. Jan 16, 2020
    rusty72cj5

    rusty72cj5 New Member

    Florida
    Joined:
    Jan 24, 2017
    Messages:
    21
    I ordered a replacement transmission mount (J1370910). I have the original bolts that connect it to the transmission but the new mount didn’t come with the threaded studs that screw into the two holes on the bottom and that connect to the cross member. (Pictured). Anybody have the part number for those? I know this set up was used on many years and Jeep vehicles during that time. Are these anything special or would a run of the mill decent grade threaded stud work from a local hardware store?
     

    Attached Files:

  2. Jan 16, 2020
    timgr

    timgr Jeepin' Nerd 2020 Sponsor 2019 Sponsor

    Medford Mass USA
    Joined:
    Aug 10, 2003
    Messages:
    20,900
    Pretty sure they are nothing special. I'd have to check the parts book later.

    Typically studs are high-grade bolts anyway, so I'd just use what fits. IIRC Napa has a pretty good assortment, or try an Ace hardware store. Or order from McMaster-Carr www.mcmaster.com
     
  3. Jan 16, 2020
    Ol Fogie

    Ol Fogie 74 cj5 304, 1943 mb 2020 Sponsor

    Jasper Georgia
    Joined:
    Nov 24, 2019
    Messages:
    183
    Our local tractor supply keeps a good supply of bolts also. Grade 5 and grade 8 . however they may have studs too.
     
  4. Jan 17, 2020
    timgr

    timgr Jeepin' Nerd 2020 Sponsor 2019 Sponsor

    Medford Mass USA
    Joined:
    Aug 10, 2003
    Messages:
    20,900
    Parts book says 2 studs are required; PN 948622. I find nothing online for these. You're going to have to find a work-alike from whatever the hardware stores have.
     

Share This Page

New Posts