I am looking for instructions on rebuilding a T-14 transmission in a 71 CJ-5 with the 225 V6. I can find instructions for the transfercase but...
Was the headlight switch loose? If the switch body was not tight in the dash then you can get a "spark" from that. This is premised on the fact...
Looking for Lock Strap(?) for the bolts that hold the brake backing plate onto the axle. the metal pieces that go between two bolts and bend up...
There is one pressure switch for each Reservoir in the dual Reservoir master cylinder. that way if one Reservoir front or rear goes empty, you...
Do you have the stock distributor? it may not be stock....
mallory part numbers: points: 25042 condenser: 400 cap: 215a rotor: 329a
Does anyone have the part numbers for the mallory dual point distributor (my dist has part no: 2562901)? (cap, rotor, points, condenser) Thanks
I had already talked to Carl. He does not have anything for the 71 V6 CJ5. He did recommend a place that could rebuild the master cylinder...
That's what I am running into... Where do you get the proportioning valve? Kent
What I have is for the V6 and has 2 different bore sizes internally with 3/8 output. I can find a reman master cylinder but it has only a single...
Anyone know where to get a dual Reservoir master cylinder or rebuild kit for a 71 cj 5? Thanks Kent
Update: Ran a wire direct from the battery to the hei unit and installed a 12v ballast resistor. Haven't had any more problems yet. In the...
I have not used the welder. This problem occurs with normal driving. Everything works fine and when I try to start it again, it won't start
Per instructions on installing the HEI, I removed the existing ballast resistor. With the engine off, voltage is 12.34 volts. I have not used a...
I installed HEI ignition in my 71 CJ5 with the Dauntless 225 engine. The problem I am having is that it keeps burning out the coils and...
What engine? What Carb?
Separate names with a comma.