Could the 'tooth' be part of bearing cage that belongs in the bearing at the output of the trany? My cage fell apart and made some interestingly...
Here is what the file I submitted to the tech section had for that drawing of the axles. I can't cut and paste the figure from my original .doc...
Ralphs - I think you have the same problem I had. What was happening was, while under constant load, the Warn Hub engagement gears will slowly...
Ya know, I haven't visited this website for a looong time and when I do, this is what I see! Makes me feel useful. I've got 'em in a file at...
I'd go for a snap ring, shouldn't be too much trouble. With my setup I had to deal with bigger issues like the hubs deciding to work themselves...
Welcome. I'm 6' 7" and fit just fine in my '70 CJ5 with notched wheel wells. Stock steering wheel, stock petals, bucket seats.
I have to confess that I've had trouble with the hubs in my custom design (see tech section). I haven't submitted a write-up of my solution(s)....
I have FF w/ hubs in the rear (my Jeep, not me). Anyway, during a hub debugging session I disengaged the rear hubs and drove in 4-wheel for a...
Zounds like you've got something in the hub that prevents the engagement gear from moving inward to engage w/ the axle end gear.
The P.O. notched the rear wheel wells about 2". Good job. Still have orginial bus style steering wheel too. I fit just fine but some of my...
I had this exact problem with the Warn hubs used in my full floater project (tech section). There are two problems happening here: 1 - The spring...
I just rotated the cylinder to TDC. That was enough to prevent the valve from falling thru. http://www.earlycj5.com/forums/showthread.php?t=29062
Rubber shift boot on top of transmission let in the elements, H2O to be exact. It is heaver than water and displaced the oil. The water froze...
I was able to install seals on my V6 that weren't supposed to fit. They consisted of rubber boots that fit tightly over the head's valve stem...
This whole thing doesn't sound right. You shouldn't have to use paper(!) gaskets in a driven interface to get the right shimming for it to work....
Take the top of the trany off and put it in reverse and 2nd at the same time.
Sorry, I've been trailing in Panamint Valley... That article was about my efforts to tighten up my steering. It was a mess, sloppy ball joints...
I added only the Pertronix sensor. I didn't notice a change in gas mileage but starting sure is a dream. I just touch the starter, for maybe a...
If you could shift in and out of 4 wheel drive while rolling on firm ground, the differential ratios are probably the same. If they weren't,...
I think they should fit. I did my D44 full floater with D27/D30 hubs. Later D30 with disks were different but you have the drummed version....
Separate names with a comma.