New GM module did the trick. It had white heat gel and the other had clean. There might be something to the white gel?? Thanks for everyone’s...
I checked the float and changed base gasket but no change. Still dies! Bought a GM module and will install it tomorrow and see there is any...
So I checked all advance parts and that are working great. For the ignition question I rigged up my volt meter so I could drive and watch the...
4 pin
The Hei power is on a relay that is triggered by the key. That was my first thought. I was thinking drop in voltage and the coil was dropping out.
Checked it and feels fine. No marks on the inside of the rotor from rubbing.
I’m thinking electrical or possibly float issues. I confirmed I had good grounds from batt to block to frame and firewall. Here’s my test drive...
Plugs look good Plug wires are new Coil is new (first thing I did) Cap and rotor new. I totally agree and practice “Change one thing at a...
I will check them. Do you think the distributor could be wore out causing it to not fire correctly? It’s a re-furbished distributor from the...
I almost think the ignition is drop out for a second and causing it to load up and backfire, but I have checked that too and everything looks right.
Filter and pump are relatively new, so is the fuel tank I’m thinking it’s fuel related also, but maybe it drops vacuum around the carb or...
71 225/auto with Hei. Runs great but of late it has developed an odd problem. Starts right up runs great then will backfire under load every now...
Thanks
Not sure how to edit title but it was MANUAL steering.
I Updated the steering in a clients 1960 CJ5. The process went really smooth and I thought I would share some pictures of the finished install....
Separate names with a comma.