Sparky, that is where I was at trying to get to, the funny rocks out of Naches, my buddy is running a motor craft carb and has no problems, he...
Hi everyone, I took my jeep up high in the cascades this weekend and found that the higher I went the less power I had, would a electric fuel pump...
here is the dash as soon as i recieve it will be powder coated then installed notice i had all removable panels for wiring simplicity, two prior...
I ordered one of those dashes custom to my wants, should be recieving it next week will post pics when i get it
Hi Everyone, Does anybody know if the axels from a International travalall the same width as a Scout 2? i found a deal on a travelall and would...
Ok I did get a chance to look at what I had, I confused the two different light sets I bought, the LED came with three wires white black and red....
They are one ? wire with a ground thru a screw anchor if they are backfeeding the what do I do? the strange part is I took the wire from the...
I just changed it and the filter so I know that is fine, I suppose I will check my wires and ground tonight
Hi everyone, I just built a new front bumper with the new warn powerhouse winch for my CJ5 I built it out of 2x4" steel with this winch being so...
[IMG] [IMG] my son and i just finished this bumper, had to extend the front 3 inches to get the winch to fit. now we want to build a different...
http://i787.photobucket.com/albums/yy151/rward64/CJ%205%20Zippy/jeepnewtires.jpg[IMG] I think I got it, i wil post pic's of new bumper and...
Th[IMG] please excuse me i am trying to figure out how to post pic's This is the day I bought her!!
Hi everyody, I was going to post pics ut still have not figured out how so soon, question, I am contiplating doing a spring over conversion and...
I usually like to do the work and fabbing myself but I think for the money this guy is asking I might have to contact him and see what he can do,...
Hi everyone, I am needing to do something with my dash the po has holes all over the existing one, should I fab a new dash or would I be better...
if your 74 / 304 is the same as mine there should be a starter silinoid on the fender hook the power to the hei on the keyed power of that this...
i hooked mine to the key on on the started silnoid the problem i found on mine was the connector i used at the distributer was able to short to...
I just replaced mine and the shackels looked similar to yours the bushings i used looked like the black ones in your pic. I just put them in and...
this might be a stupid question, but i don't know Is a IHC 304 the same as a AMC 304?
ok first off i only have 11.5 volts or a little mor but not a full 12 i have about 13.5 to 14 at alt. can i wire this direct without harming...
Separate names with a comma.