Thanks, I cleaned up the old one with some sandpaper. I think it will make due.
[IMG] [IMG]
Thanks for the pic! That’s the washer I’m talking about. The small end of my cluster gear has no notches for that washer. I think I’m going to...
i have just started to rebuild a T90 with a Novak kit. I just figured out that the small end of the cluster gear does not have the two keyways cut...
Swapped in the original capacitor last night. Still misfiring at idle, but it cleared up the rest of the RPM range pretty good. It's at least a...
Brand new, no ethanol.
Thanks I’ll look into this.
Clip was still in rotor, it was able to turn probably 10 degrees (5 each way) without the shaft moving points spring felt much better than the...
I also do not have a vacuum gauge yet. Can you recommend a decent one that won’t break the bank?
Yes it is 5BTC and mostly steady except for a rhythmic skip. I describe the shaft as slight as in perceptible but not loose or wobbly. The dwell...
Well first thing I found is that new rotor had a ton of play in it so I swapped to old rotor. No significant change. Twisting the rotor...
Thanks, I’ll swap the condenser and run theses test. I’ll let you know what I find out.
I did the 11s on the front at the end of last year. Huge improvements I still have 9s on the rear. I bought the kit from Herm’s to save time and...
Condenser was also replaced. Wires, coil, and plugs are new as of the end of last summer.
Ok, only had the jeep since last summer. F head engine. Started chugging at a lower speed than it used to and misfires a lot at idle so I started...
I think we have the culprit. This is the old pump that came with my jeep when i bought it. [IMG] [IMG]
Thanks for all the info! I'm willing to bet this is correct. The previous owner said he replaced the fuel pump a while ago. I think i have the old...
I pulled my F head pan to replace the gasket and i found this in the bottom nestled under the drain plug. At first I thought it was a magnet or...
Yea, I’m looking for a better one locally but I’m not having much luck so far. I’m hoping as the weather starts warming up, more parts will show...
Are the ones you can buy online work buying? I have to replace most of the guys so I may just put it all in a new case too.
Separate names with a comma.