:D Wife wont let me park in garage if I don't fix it when i do this rebuild.
Well I have the motor taken apart and started ordering parts. Will be dropping the block off at the shop next week to get cleaned and bored....
this is what Cyl 3 and 4 looked liked
[ATTACH]
well with the 31 inch tires and 3.73 gears at 60 mhp I am only running at 2800 rpm so i didn't think i was being to hard on the motor
well I pulled the motor last night and started breaking it down. number 4 cyc looks like it broke a ring and chipped the top edge of piston which...
no I did not add oil but should have now that you mentioned it. I will have to check that tonight
I did a compression test last night 105, 100, 100, 95, measured front of motor to back
I have verified the gears they are 3.73 date stamped 1969. I think I will pull into garage tomorrow and pull motor and start the break down and...
I purchased the CJ5 in this configuration overall I am happy with the 134f that is in it I use it as my daily driver back and forth to work and...
I have a 1969 CJ5 current configuration is 134f with T90a trans and 3.73 gears. The motor needs rebuilt (rod bearing knocking). My question is...
I know the engine is original and the puzzling thing is that the date on the front and rear gears match the year of the jeep. This is all new to me
OK I just opened the front cover and glad I did. looked like oil in it had not ever been changed. but the gears look good. the stamp on it is 9...
I just finished rebuilding the F134 the compression was at 75,70,65,90 front to back. I just tore it down put new bearings in and new rings....
just from some of the stuff I have been reading I didn't think they put that low of a gear with the F134. But I have a lot to learn and its...
just thought it was strange to come from factory on a jeep with a F134 in it.
So my next question would be was this a factory setup or something someone changed out.
I recently purchased a 1969 CJ5 with a Dana 27 front end and 44 in the rear . The rear gear is stamped as follows 11 26 68 DANA 18515 A3058 41-11...
I want to thank all of you for the Info and reply's. It is nice to have some place to go to get info when you need it. This is my first jeep and...
thank you for the info. and the patience with a newbe. I will keep looking and finish the brake master cylinder upgrade i started and have it...
Separate names with a comma.