Check this out guys.
How can I tell whether these are duo-servo brakes on my 1960 CJ6? I'm trying to figure out if the short shoe should face front or back.[ATTACH]...
I'm 35 and fairly strong so I hope I can do it that way in my driveway without buying more tools. Another thread got me thinking about tooth...
Do I need special tools for that? Are they very heavy?
Would it be easier to drop the transmission or engine to get at the flywheel?
I think shimming the starter would only make it worse since the Bendix gear wouldn't be able to reach as much of the ring gear tooth.
I don't think I have the tools (at least) to drop the engine or transmission to access the flywheel. What should I expect to pay for that?
I've tried two starters so I've checked them out carefully. Do you mean it may not be engaging properly? I'm not sure how disengagement relates....
I had the original starter before and I was sure to get a starter with the same tooth count when I got an aftermarket one. I know nearly half a...
I recommend having the starter rebuilt. I tried to replace the drive gear on mine and it was tough. Eventually I couldn't get the brushes back...
I've had my 1960 CJ6 for a few months and from the beginning the starter grinds about half the time I try to start it. I replaced the starter and...
How was the flywheel change? Did you drop the engine?
Thanks! And the 20psi FSM tire pressure applies even though I don't have factory size tires?
How can I figure out what the tire pressure should be on a 1960 CJ6 with 7.50-16LT tires? I have a digital pressure tester and I'm getting about...
Will do. Will one extra hanger do it? Is it easy enough to disconnect the current pipe from the engine?
You're right of course, but I like to learn hands on. Luckily this isn't my daily driver. But I would like to know what I'm getting into before...
Walck's told me I'd have to cut one of the pipes in the kit in order to put the 20" section in the right place. What should I use to cut? What...
Aren't clamps more prone to leaking than welding is?
OK I'll just take the Walck's kit to a muffler shop and have them install it. What would be a fair price for that? Any instructions I should...
Dang. I'd sure prefer not to have to find a 20" section of tailpipe. I'll see if Walck's can cancel my order. If not, should I be able to...
Separate names with a comma.