Electric fan is awesome. I pulled the fan from a mid-90’s V6 Camaro and the whole shroud and everything with it fits the mustang radiator nearly...
I have a mustang radiator with my ‘98 4.3. I cut the engine outlet/radiator inlet pipe on the top of the motor and rotated it about 90 degrees to...
That totally make sense! The bikini top doesn't sound like a great solution. Interested to see what you come up with.
I see you are in Texas. I gave up on a full top a number of years ago and just use a Bestop bikini top and the half doors from the Kayline full...
I do have to credit you as your post was essentially what I was trying to do. Unfortunately when I drilled the non-zerk side of the pin it started...
I actually think that it looks like there's a step there because I had drilled through the center of the pin but it still wouldn't move so I...
Not sure where this thread is headed but the pivot pin is out. Pivot Pin 1 by KarlWithaK posted Sep 5, 2023 at 10:24 PM Pivot Pin 2 by...
:D Ignorance tends to have such a negative connotation. I prefer directed naivety. If it wasn’t for that I’d probably never start these projects.
Have you considered flat towing it? I have a full floater kit on my Dana 44 rear axle so I have hubs on all 4 corners. I can just unlock all 4...
Thanks for the additional info. It does not appear that the lock screw is in there. It was not installed when I received the case so it is...
I've read through several threads here about the shift lever pivot pin. I'm disassembling a case I bought a week or so ago but I can't get the...
Haha, fair enough. :D
Went round two with the rear output last night. Unfortunately no real smoking gun. I'm not going to mess with it again for now even if its...
To clarify, I was asking specifically about the yokes, not the seals. Im already using the Timken 473229 seals.
Fair point and I’ve never though much of it in the 25 years it’s been set up like that. That’s a lot of height for a single shear joint. Probably...
Well I haven’t had time to pull the rear output yoke back off but I plan to do it this week. It seems like everyone here is saying to avoid the...
This might not be relevant to the most recent posts but thought I'd post up pics of my steering setup with saginaw power steering. I also have a...
I will keep you posted I’m thinking that maybe the shaft is worn down at one spot and maybe the seals fell right on that spot. I suppose the...
I see what you are referring to there. I didn't remove that section of the output housing so nothing changed there that I would have thought would...
I'm not necessarily 100% positive but I used a 4 foot cheater bar on my breaker bar so I would like to 'think' so. I haven't seen any mention of...
Separate names with a comma.