So is this a direct swap onto a 2bl odd fire 231? http://www.holley.com/502-20S.asp
i own all 4.....
Not sure what models of jeep these are off of, can someone help?
Says your hompage cannot be found.
okay so I swapped in my SM420 and have a D20. Anyone have any ideas or designs or pictures for a skid plate?
Wehn Imounted mine, my box was so long i had to notch the cross member to get it too fit, my cross memeber looks different that the one in the...
not so worried about the plumbing and wiring as I am about the mounting. there is tons of info on plumbing, but not so much on mounting to a 231....
Has anyone made this mount, to mount the York to a 225/231 for OBA. Or something similar to it?...
I will second the snap on one for quality ( it is what i have). But if you want to go cheap and are only using it for a few bends Harbor Freight...
ahhh makes more sense thanks
thanks you guys! i will have to see what I can figure out on my set up since I want to keep the rear seat
I think I get what you are saying, do you have dual exhaust? If so how you going to tie in the front hoop? And also, How about the rear part...
Kind of a thread Hi-jack....but could provide useful. How does everyone tie their cage into the frame? I just got a full cage and want to tie...
HMMM lots of fabrication. I would really like it inside the frame since I want to put a 6 point cage and tie it into the frame. Any ideas of how...
Do you "have" to plug it. if it doesn't hurt anything to keep it open ( and I don't see how lubrication could) why not just leave it open? Just...
yes bench bled MC. Will check Claps, but I am pretty I got them right
Oh yeah and as far as Autozone, there is a reason they have a lifetime warranty. I had a buddy that bought a starter from them for his jeep had...
reason being, is the the CEL can set off a code for one thing, such as running lean/bad read from O2 sensor. So Autozone will tell them they need...
pretty much all new lines, and components, wheell cylinders, calipers, etc... I guess I will just bleed and bleeed
Okay I have a 71 Master Cylinder. Scout 44's with disks up front. I removed the 10ld residual on the front port and added an inline 2lb, and added...
Separate names with a comma.