I have the t90-a i believe. I will check novak's site to see if they have info on input shaft differences.
Does anyone know if the T-90 from a cj5 will fit in a cj2a? If not what is different from one to the other? Thanks
Thanks for all the ideas, that will definitely help.
I am going to be removing the f134 engine from my cj5, and I was wondering where are the lift points on this motor? I assume there is somewhere I...
Thankfully my jeep came with the "front frame corrosion protection feature" also known as a leaky hydraulic pump, which liberally coated the frame...
Thanks for the help, it sound like the pressure washer is the way to go.
I am getting ready to apply the por-15 on the front half of my frame but I have run into issues with the boxed areas in the front. Inside both...
Since my winter break from school is now over I figured it would be a good time to post up some pics of the progress I made over the last month....
I have begun ordering my new brake parts for my 59 cj5 , but I hit a snag. I ordered the shorter front lines instead of the longer ones. I am...
That makes sense, it is hard to tell for sure how wide that back panel is from the pictures I have found of other koenig cabs. What is supposed to...
I was hoping I could get some info about the hard top that came with my jeep. Im sure it is a koenig, because it still has the tag on the side...
Is there a place that I could get the specs and wear tolerances for the transmission? Having pitted gears is easy enough to diagnose, but what...
Is there a parts source that will have the good parts? I would rather get it right the first time, but I have looked at a lot of the websites for...
Ok, thanks for the help. I will start rounding up the parts.
The bearing races are good (the ones on the steering shaft). They have really light pitting, that is about the extent of the damage. The bearing...
Where is a good place to find gears? The ones I have seen, from Krage for example, are all about 90 bucks apiece. For the price of a couple of...
Ok, I have pics of the sector shaft and the box missing the end cap. I forgot to pick up the steering shaft from the shop this morning, but just...
Brian, I appreciate the help, after your suggestion I may try to temporarily salvage the box until I can find a better setup. The worm gear is...
Im glad to hear that, I have enough other stuff to spend money on without a new tranny and transfer case. Since it will only be driven on the farm...
Ok, I finally got the steering box pulled. It was fairly easy to do. It turns out the problem was that the bearings had fallen out of their races....
Separate names with a comma.