That's a nice clean installation, I have the same heater waiting to be installed in my 3B. Any issues bleeding the system?
Well, I like them , but the wife thinks they're too "big". Might be too much a move up from her civic. Seeing as she's the one that's going to...
These things are starting to follow me home :) did a little horse trading and ended up with another CJ6 tub, its in a bit better condition than...
Sounds like pretty minor issues to me, they wouldn't scare me away. I'm used too my jeeps leaking oil:shock:( mostley gear oil though ) i'll check...
Any feedback on the 2014 Cherokee's? Looking to replace the wife's Civic (02 with 285 thousand km's ) with a slightly used 4banger . I'll be the...
Managed to find a chunk of 3/4 at work,have to add a 1/8 spacer to make up the 7/8th factory length. bribed a welder with some Cuban cigars to...
Tossed a bit of oil in the cylinders, got 120-120-0-125.. stuck rings and a exhaust valve? pulled the valve cover, intake valve seems to move as...
managed to pull the T-90 from the frame today, and look at this: [IMG] [IMG] t90 indexes exactly on the t98 bearing retainer... I did not...
Not much to report, had to build a franken starter to check compression on the f-head that is going in the 6. 90-90-0-30 :( Probably valves on...
I used to have a 52 willys truck with a carter, ran like pooh, replaced it with a solex and never looked at it again. Got rid of the uneven idle...
Thanks oldtime, you're a wealth of knowledge:)
Apparently the T98 that came with my 6 is the original transmision, explaines the 2" or so further back mounting point for the clutch tube and...
A lot of welding is an understatement, :) i don't think there's a panel that doesn't need repair on this thing :( Frame seems OK though, couple...
Figured i'd start a post, no guarantee i'll get it done. what i'm starting with: [IMG] as it was loaded on a trailer heading for the scrap heap...
Separate names with a comma.