Sorry to go digging, but those are 33" Buckshot Mudders, about 6 or 7" wide and bias 6 ply I believe. The original Buckshot Mudders that made...
I know I'm late here, but take a look at my thread. I was having the same problems, but fortunately my front disc brakes were dragging so bad I...
Well just to update, I had pulled the master cylinder apart and removed the check valve altogether. I cleaned it up and put it back together (it...
Yes, I bought a 10lb in the rear for the drums, and 2lb in the front for the discs.
Sorry to dig this up guys, but I'm in a bit of a pickle with finding a solution to the fill plug. I did some research and puchased a few steel...
If you can rotate the front hubs/discs and rotate them by hand then they should be fine, as long as they don't heat up to an extreme and you don't...
Well, your MC should have the check valve in it and it should cause those disc brakes to drag because the calipers don't release all the way, in...
You say you installed a new MC, did you remove the check valve? I found that the check valve in mine is actually internal so you have to pull the...
Thanks, that's just what I needed to hear (someone else using the single chamber MC). I'm going to go ahead and order the inline residual pressure...
Hello all, I've done a ton of research on the disc brake conversion and found a ton of posts here with a wealth of information, but none of it...
Hello all, I picked up a 1961 Willys 4x4 station wagon in great restorable condition and intend to be restoring it in the next few years. I'm...
Separate names with a comma.