Very good pictures from TXTOLLER I can see all the detail I need. I see the two diagonal floor braces. Thank you very much This piece and the...
I have two 60 gal tanks with one pump. 3.7hp/ 11.7cfm @ 90 psi. If I buy another equal pump, then I should have 23cfm @ 90psi and 120 gal...
Thank you for the pictures. What piece of sheet metal is at the rear of the floor by the bumper? Classic enterprises has 4 "rear floor diagonal...
I posted pictures of the tub on this forum under "CJ6 tub" I can't use a rotisserrie until I find a way to make the back end more rigid
[ATTACH] [ATTACH] [ATTACH]
Anyone have tips / suggestions / comments on sandblasting a tub for a cj6?
I am ready to work on the tub of a 1974 cj6 to finish my jeep. I picked the jeep up almost 15 years ago and tore it apart. Three years ago, I...
I have a 2002 F350 dually with aluminum wheels. It came with four aluminum wheels and the inside dually wheels had steel rims. The aluminum rims...
I bought a plate for my 74. I have not installed it yet. I believe it is made for a 76. I need to do a little fabricating
I would think the sun is pretty hot in Vegas ...
I removed the HPOP and saw no oil pump to the reservoir while cranking. I even jacked the rear of the truck up 12" incase the pickup was cracked....
The replaced pigtail is for the engine harness to the driver side injectors. Instead of staggering the leads, they are all cut the same length and...
2002 7.3 diesel, 2WD, supercab, dually, 282,000 miles daily driver I was not getting oil to feed the HPOP (high pressure oil pump). Either the...
Tomorrow morning I am going to a good alt, starter etc rebuilder and seeing about the pulley on my alt and find out about the output. I ordered...
I have to replace the alt that came with the jeep, has blades behind the pulley that won't let it fit on the stock 1974 alt bracket. Alt mount at...
It would be nice to view a finished project. Get some tips... I am past the hard parts. Everything is on the frame. The engine runs. I have to...
anyone have a cj that I can look at near Chicago? (Brookfield Zoo area) Other than this forum, I am doing this blind
Thanks again for suggestions and help
The pulley in question is the one that bolts to the front of the damper. It doesn't conform to the shape of the inside of the balancer and...
I did not want to but I guess I will have to the correct alternator and water pump. I see problems removing the water pump bolts
Separate names with a comma.