Both headlights quit simultaneously. Bulbs both check out. Parking lights, tail lights, turn signals all work. All of the painted labels on my...
My 74 has good power to everything except to starter. Battery has good charge. Jeep runs fine when I jump start it by rolling down driveway and...
Driving along yesterday evening in my 74 (304, Howell TBI) with heater on, and pulled headlight switch on. Everything went dead. No power to...
Never done any brake work, but I have had two master cylinders installed on my 74 (77 frame and running gear) and I still have no brake pedal when...
PO installed new gas tank and filler tube; looks like everything done right. But, I have always had to trickle the gas into the tank or else the...
Need pix of rear bumper(s) that came stock on 72-75 cj5. Thank you.
I'm trying to de-hack my transmission tunnel sheet metal and shifter boots. Would very much appreciate pix of what stock tunnel sheet metal and...
My T150 3-speed shifts fine when it is cold. After it heats up, it gets harder to shift, particularly when trying to pull it back into first gear...
Pro-Tools (Tampa, FL) appears to have the best price on an electric bead roller and die sets that I can find. Does anyone have any experience -...
Am going to install the headlight relay upgrade this weekend, and would like to upgrade the lamps at the same time. Does anyone have a headlamp...
I finally got around to installing my Howell EFI last month. It makes an unbelievable difference in startup and driveability. I have blocked off...
[IMG][/IMG] The linked pic is of the intake manifold of my 304, between the oil filler tube and the thermostat housing. I found a detailed...
I installed a Heatercraft heater last year, which required running heater hoses through the firewall behind the glove box and into the side of the...
This is my second post on this - a year later. On my 304, oil runs out of the hole in the timing cover where the distributor shaft goes in. The...
Previous owner of my 74 welded diamond plate on top of the floorboards, creating a trough or gutter about 3/8" wide betweem the diamond plate and...
I recently picked up a Bantam trailer and would like to build a hinged frame to go over the top and bolt a roof top tent to the frame, similar to...
I'm taking my trailer in for media blasting. What should I use to protect the bare sheet metal while I am performing repairs? I remember reading...
I'm planning a trailer build. I am going to make it 4' x 6' with a plywood camping box and roof top tent. I'm going to use 15 x 8 wheels and a...
I want a new compressor that will run a sander, die grinders, and a paint gun in addition to my impact tools. Of course I don't want to spend too...
I know this is difficult without a picture, but I'm going to try anyway. I recently welded a piece of 18 guage into the front of my driver's side...
Separate names with a comma.