I dropped the trans tonight and it was indeed that the clutch disk was backwards. I appreciate the help in correctly diagnosing this prob. I...
Thank you for all the help, Your forum support is awesome. I'll give an update of what I find Thanks again Brad
I'll double check the transmission, that could complicate things
I am going to conclude that the disk is backwards since I adjusted the linkage out a lot more than it was with no results. I'll drop the trans...
The clutch plate is flush against the flywheel so I believe it is installed correctly
Thanks for checking out my problem. I have a 74 CJ5, 304 T150 that had a new Luk clutch kit installed in it by a mechanic. After the install I...
Ok, its been a few months and I finally focused again on my steering issue. (I had to swap engines, and I also bought a semi-built xj that I...
Thanks for the advice, I got her bolted in. I was first going to unbolt the transmission mount on the crossmember, but opted to just unbolt...
Hi, I am trying to put my 74 back together. It has a 304 with 3 speed. The engine is bolted to the trans and I have the driver's side motor...
ok. I started it up, took off the top of the carb, and adjusted the float (it was close). How touchy is the float level relative to proper carb...
Thanks for the replies. I will check the vacuum issues and point gaps, as well as timing. Would an engine idle and rev up well if the timing were...
Hi, I have spent hours on here searching through posts and hours in the garage trying to get my 74 CJ5, 304 going. Rebuilding the carb is the...
Thanks for the help. As far as it not working well, it feels like I have little or no power steering. I checked the fluid and it is good. Any...
Just started driving this Jeep. It drives straight down the road, but when turning left, it doesn't turn as sharp on when turning to the right....
Separate names with a comma.