noise in neutral only when clucth is depressed..or changing gears...does that sound better? everything else fine
i replaced it...i just hope it's not another transfer case!
it's a basic centerforce clutch.. it's funny i here this about the stageII centerforce clutches for mustang's,and i got almost 9yrs out of it...
funny thing it did it OUT of gear but with clutch pushed in. keep the questions up,cause i'm sure the reply's you are giving me will lead to an...
yes it was replaced...when i replace or tear down something everything gets rebuilt or replaced..a $10 part like that can cost a transmission.......
well it's a little warmer today,and i pulled the dust boot off and had a buddy push clutch in and out and the t-bearing is just above the fingers...
it is all hydraulic btw
yes it does this sitting still.. have an idea how i can fix it? i used all the right parts..i thought.
i put all brand new clutch(centerforce) fork,springs,throwout bearing,and flywheel. i maybe have 800 miles on the stuff,and like most here who...
never mind i got it all done...thanks anyways
i'm getting ready to install my new steering shaft and gsteering gear box,and went ahead a purchased a set of hedman fender exit chevy 350...
that's a great idea thanks!...
here are the pics
after inspecting alot more closely...the crack wasn't where i thought it was.. the crack is where the sway bar bushing bracket mounts...
anybody have a 350 swap in a cj using headers of any type?
http://www.tdperformance.com/products/Default.asp?id=3286&iset=7580&rsku= my mount looks like this
yeah it's been a while i last visited...moving sucks! i plan on doing some modding,and i'm looking for some pics and advice. project at hand...
packing 1 ft of snow would do this?
one more thing since this is a t-5/300 what do i need measure on the couple of dana's i located? i think this was a 84 t5?
i talked to a guy at novak,and he said my front shaft with a bad yoke was push'n into the transfer case,and was binding the bearing/race? it...
Separate names with a comma.