Thanks. I think I'll buy it.
Any body know if a hard top off a 1964 cj5 will fit on my 1961 cj5? I see one on craigslist for 500 dollars.
OK guys thanks. I went to the technical library and from there followed the link to Novak conversions. I see what I need and will order it...
Is the rear seal easy to find? Do I need any special tools?
I have a 1961 CJ5. F head. T 90. stock. On the aft end of the transfer case is a drum looking thing that is attached to the drive shaft. It looks...
thanks guys. I'm still looking for the rest of the parts to build a new F head. I just ran across a good 250 for 100 dollars and was entertaining...
does the v6 bolt up to the t90, or do you have to change the trany as well?
Hey guys. Just out of curiosity. How much work would it take to put a straight 6 chevy engine out of an older camero in a 1961 cj5? I couldn't...
OK, I think I"ll pass on the L head and look for the rest of the F head parts. Thanks guys
thanks, I think i'll try that
I have an F 134 block, head, oil pump, water pump, valve cover, gen., crankshaft, and some other parts. I would like to build a new engine for my...
the sound does go away if you let off the gas or push in the clutch. 15 inch tires. I don't know much about tires but they look pretty nobby. like...
2wd
I understand about the motor mounts, I once had a car that had a bad mount and would rock back and forth. But this is only when you really get the...
today I picked up gear oil and gasket material. tomorrow I'm going to check all the oil levels, and see how things look. I had a friend ride with...
By the way, it's a 1961 cj5, with f head, t-90, 18 all stock. in the previous post.
I have a scraping sound in 3rd gear that goes away when I left off the gas pedal. It's not the normal whinning sound the transfer case makes. Any...
So..my new old 1961 cj5 is running pretty well now. The smoke has all but cleared up with the use of Bardahls additive. My father in law said it...
I understand the compression check. Leak down? How do you do that?
If it means rebuilding the engine, where do you recomend I get the parts?
Separate names with a comma.