I would like to resurrect wiper motor for my 78 CJ5. I lost the damn brush springs and the 2 long small bolts that hold the motor to the gear box...
I stuck vents in both of the valve covers on my SBC. Since it's V8 there is one hole in each valve cover. I didn't realize there is a function...
That came along with frame change as well. Is 76 the fateful date when AMC bought Jeep? AMC almost destroyed Harley Davidson. The wiper motor...
I lost a quart of oil last week trying to pull 3 grand down the highway and keep up with "newer" jeeps. It came out my well sealed oil pan...
Plugged oil gallies in the head from years of dirty oil deposits. Especially if you have blow by. You could pull both valve cover and if you...
Purpose is to set bearing preload. I don't know if all pinion shafts use this method to set the prefload.
is there a crush sleeve present as some fords have that I've worked on?
I just did a SM420 w/Novak adapter to D300 in my CJ5. The rear drive shaft is 16.5" long and seems to work well. I converted to CV style shaft....
Thanks for the info. Do some vendors know thier ohms? I certainly haven't seen them listed.
Any one ever install Jeep oil sending unit into a small block chevy? I bought the chevy sending unit hoping it would work with my jeep oil...
Ithink the float setting was too low. I lowered it and winding out in second gear on street I got the same condition that I did on the hill. I...
Who would stock an "offroad kit" for the q-jet? Ever heard of mounting the carb backwards? Would be tricky without square bore intake. PLus I...
This weekend I discovered the quadrajet on my SBC doesn't do well up long steep hills. With constant throttle position the engine speeds up and...
Well, I actually put the cover on the tranny and it seems to shift fine on my bench now. It is not in my CJ-5 yet. Apparently I was moving the...
I don't see breather hole on my SM420 I am installing right now. Anyone know about this? Maybe the stick pivot joint is not air tight so it...
I got this tranny from friend. I believe it shifted into all gears before I opened it up for rebuild. I have installed rebuild kit from Novak...
2nd link attempt Maybe this link will work. I put a space between the forward slashes which you'll have to delete. http://...
Here is couple images of what I'm working on: http://picasaweb.google.com/hansw3/S...D300AdapterPic It would be great to get actual CAD...
Looking for CAD data on D300 and SM420. I am mating the 2 together and this would be great to have! (2D or 3D)
I am looking for much higher crawl ratio out of my cj5. I am running an SBC w/AA bellhousing to T150 and D20 with 4:56 axle gears. I have SM465...
Separate names with a comma.