There is one post on ignition switch that does not loose power when cranking. The “Accessory” post does lose power when cranking.
I call it “The Hook”. Works very well. Easy to move around inside body and pull dents. [img] [img] [img] Wish I had a decent closeup of the...
Understood. Keep me in mind for the transmission and TC together. Not really interested in a PTO. Not many folks are unless doing a real...
Bondo once… [img] Bondo twice… [img] It’s going to need one more round.
Any good condition t-14 or t90 ? Or 4speeds? good condition fenders? I could probably use a spare D18 transfer case(v6 version). We have family...
[IMG] [IMG] 11" intermediate drums YJ pedal Rear cables ‘74CJ Cable clamp homemade Front cable from- I don’t remember but I did have to shorten...
Jeff really likes this stuff and is a lot more accurate than me so I mostly just let him at it. [img] We used the Hook and winch again with...
My tube fenders were pretty simple. Page 30 of my build. Call text or message me if you want more details....
They have a lot more than tops from this manufacturer. I just bought several new parts for the project I’m working on. Some of the items much...
This may be bad advice but I’m sure I read it here so.. To get flairs tight I put a tiny dab of anti-seize grease on the flair - where the nut...
This afternoon I dug into the passenger corner. “Dug” seems like the correct term. [img] After blasting through with the paint remover disk I...
Besides some final details just before painting the driver side is done. [img] [img]
The color she picked is actually pretty close to the original Spruce Tip Green. [img] Maybe.. [img]
I’ll take the spare one off your hands. :drool;
THE BOAT.
So the Hook I made worked very well. There were big dents in the light panel and the corner piece. Very light coat of filler has things looking...
It’s not much pressure. If anything broke it would just fall to the ground.
The Hook. [IMG] Power to pull the body apart if I’m not careful. [img] It’s working!! Easy pulls with lots of tapping with a hammer. [IMG]
Got the patch panels welded in on driver side. Everyone needs one of these. Easy to cut 16ga straight, round, or crooked. [img] Ryan isn’t...
It looks like 15/16”. I’d call it an inch. [img]
Separate names with a comma.