How skinny? Interco sells some 15's that are 9.5" or skinnier.
I finally found the time to work on this again. I ended up using a dremel with a small cutoff wheel and cut through the inner race almost all the...
I watched the metalshaper one. Unfortunately (fortunately for him) the bearing in question is just loose on the shaft in his somehow, so he...
From Novak's site: Drive a large screwdriver or similar shaped tool between the front bearing and the output gear to separate the gear enough to...
Hello all, I am currently taking apart a Dana 18 with the larger 1 1/4" intermediate shaft to build a combo D18/D20 for my '74 CJ5. I am asking...
I don't have a picture but I put them at the top of the windshield on my '74 CJ5. There were two holes on each side of the windshield frame. I...
I just bought a 1973 John Deere 110 with additional snow blower front attachment. My grandpa was into John Deere's and had a huge collection of...
#12 on this page? 1955-1986 Jeep CJ5, CJ7, CJ8 Scrambler Parts|Jeep Exhaust Parts|Morris 4x4 Center
Carandcoffee by scuter83 posted Mar 6, 2018 at 1:05 PM One of the other toys. 1988 Mazda RX7 with basically a cam'd LS3/T56.
Jeep Speedometer Gear Tooth Chart
Jeep CJ5, CJ7, CJ8 | A/C & Heating Parts | Morris 4x4 Center
So the primary lead wire going into the distributor had..uh....let's just say a less than favorable electrical connection. Red-did that and it...
Ok, so some background. 1974 CJ5 258 re-wired with an ezwiring 21 circuit harness. Jeep stored over winter and the battery went down,...
hmmm, I have a fiberglass tub, so re-doing floors doesn't sound that fun to me. Seems like it is too much work for what I use the Jeep for...
I have the option to buy a rebuilt T-18 that came out of a 77 Cherokee with bell housing and listed as having the Texas Bolt Pattern. The thing...
So I took the Jeep out on Sunday to test out how quiet the new manifold was and make sure everything was working. Everything was going well...
At the top of the pedal, I have about that. My problem is that before all this, the clutch would engage with my foot ~1-2 inches from the...
I went offroading a couple weeks ago and the clutch bracket that bolts to the bell housing started to loosen. Got to the point where I couldn't...
Separate names with a comma.