Interesting. Be safe.
Are you going to add a wall bracket near the top of the post?
I agree, they look pretty cool. Tire Tool Tray - Bolt Together – TMR Customs
I agree with everything you said. I also believe based on the original question of adding a lunchbox locker to his jeep with 33x10.50 tires and...
To the original question, suffice to say, if you lock up the front axle you will have difficult steering.
I agree. I can only imagine the anger felt had it broke while out driving.
Check out these two. These small cap HEI distributors are an inch smaller in diameter than the standard GM HEI distributor. Amazon.com: A-Team...
I don't know if this helps or not, but the discussion may at least identify which circuits the wires are connected to. Steering Column Wiring...
If you decide to use the GM brakes, look at this post by Focker. There are alot of pictures and discussion that answer some of your questions....
I guess I look at things a little differently. I certainly understand your frustration but why not contact the manufacture, explain the problem of...
The recommended Permatex gasket maker product works extremely well. I have used it and I have seen where others have used it with great success.
Personally, considering the location of the damaged area in relationship to the output shaft, bearing and gear, I would not do any of the "hot"...
No argument from me. The original photo gave the appearance of beehive shaped valve springs. Probably the shadowing in the picture.
I know Pete. Would you feel better if I say, upper valve train?
Those springs look like beehive springs and the smaller end, more open end are always installed toward the the rocker. The reason being, there is...
Why wouldn't it? With copper, I may not pull quite as hard because it is soft but, all you are trying to do is removing the set caused by rolling...
When we were building and installing boilers, we had alot of tubing to install for the pneumatic controls and chemical injection systems. It...
In my case, your link to the introductory thread does not work. It gives me an error code saying I need to log in and of course I was logged in.
Probably so. I'll go sit in my corner now.
Not according to the MSDS. The material safety data sheet does not list any silicone in its chemical makeup.
Separate names with a comma.