I swapped in an SM420/Dana18 TC, so I'm not sure about the differences in clearance, but I kept the original small yokes because driveshaft yoke...
My tank leaks from the filler cap as well. It's a new plastic tank, and I tried both the old factory gas cap and a new one to no avail. I've...
Hmm.. I've always had trouble putting the two together rather than pulling them apart? Is the crossmember still bolted to the tranny/tc and to the...
It looks like the clutch fork is sliding around on the clutch fork pivot ball. Pull it one way (like towards the driver) then try to move the...
I too agree with the points and condenser. My '69 with the dauntless sat in a field for over 15 years, I brought it home as it was, stuck a new...
Is the T90 mated to a Dana 18? At any rate, it's hard for me to believe that the fluid coming out of the bellhousing, where the clutch fork is, is...
2nd the front seal... Looks like oil is blowing out of the hole in the bell housing where the clutch fork is. It would just about have to be input...
Same set up here; SM420 (with ribs) and d18 with the small yoke too. Here's the best picture I was able to get from underneath the jeep. This is...
I have the exact same symptoms on my 69'... replaced the MC as well to no avail. To do anything close to an abrupt stop, it's like doing a leg...
Mine started with that same sound a month or two ago. I figured I'd jarred loose some carbon or something. Long story short, half a bottle of sea...
how about a cheap boat cover?
I second Glenn. My under-seat plastic tank is really tough plastic, it would take some serious abuse to harm the threads for the gas cap. The only...
Well, in case anyone else has similar problems, after yet another tear down, I finally figured out there was some kind of bind in the countershaft...
I found out last night that the center metal on the friction plate where the input shaft splines go through was riding against the input shaft...
Clutch linkage would be believable for me IF it would not have shifted/downshifted perfectly for two days of driving after the install. However, I...
Well, I ended up washing out the flywheel/clutch/bellhousing and didn't have any change. Adjusted the clutch linkage as much either way as...
No e-brake or that would be a good idea haha. The sm420 in my jeep has been the best mod I have done so far! I used the stock flywheel, same...
Thanks for the responses guys. I will check all the bolts this evening after church. The mud I was in was pretty gritty, and it was about 28 here...
I just put an SM420 into my 1969 CJ5 with 225 v6 a few days ago. While everything was out, I put in a new clutch set. Got the tranny and dana 18...
12 gauge should work for everything like tail lights, park lamps, etc. I used 10 gauge for the headlights and electric fan though... 10 gauge is...
Separate names with a comma.