How do you do this?
Surefire solution is to install a master battery cutoff switch. They are only $20, and work great. They install between the negative cable and the...
x2 LTB's are great tires.
I was installing the Warn overdrive tonight, and found that it hits the bottom of the floor pan on the Jeep; has anyone ran into this problem? I...
Get in touch with Herm the Overdirve Guy, I know he rebuilds a lot of differnt Jeep tranny's, and only charges around $100 for labor. He is...
I know we just talked about this for a later model CJ, however does anyone have a picture of the way the Clutch Fork is suppose to fit into the...
Yeah, my PTO pokes through the floor about 1/2 inch or so.
What have other members done? I was thinking about fabricating a new seat mount, but if there was an easier solution, I would love to hear about...
Great idea!
I am installing an overdrive in the jeep, which means that I have to move the PTO lever back about six inches. It looks like this will place it...
I have been looking at softer, high-back seat replacement for a while too; however I am scared that all of the aftermarket seats will not leave...
I use the Exide Orbital. It is sealed like the Optima’s, but cost much less. I have ran it for over a year with no problems.
As everyone else has said, go with Herm
The difference between the front shift and rear shift overdrives is that the front shift is for transfer cases with 26 teeth and the rear shift is...
Ahh that makes sense. :D Do you know if this specialty item, or will a regular auto parts store stock it? Thanks a lot!
I need some help. I ordered a new brake switch for my 64’ CJ5, but I can’t figure out what type of connection to use to wire it in. All of the...
50-52, but that is reving it pretty high. I am content with 45 mph!!
Thanks!:)
I just had a new exhaust put on today, and wow what a difference it made. The old exhaust had lots of build up and was full of pinches and dents....
This is my 64' with a ProComp 2.5" lift. Hope it helps!
Separate names with a comma.