Thanks! That link will be in my favorites from now on.
Hi guys, I'm looking for the proper torque for the pressure plate on my Jeep. It has a 304 with an 11" 3 finger clutch. Probably out of an 73 or...
The inspection cover is missing. Also it has another hole in the bottom of the bell housing. There is nothing sitting in the bottom of the bell...
I don't think you would call it through the floor pedals. The pedal hinges from above and a rod goes down to a...something that bolts to the frame...
When the living room gets painted and the water damage in the bathroom gets repaired...I'll pull it down and give it a good inspection.
Last night I went to press the clutch pedal and it was higher than normal. I pushed it in and when I let it out there was alot of grinding. I made...
You might be able borrow a comp. guage from an auto parts store. Auto Zone loans alot of tools at no charge. Do you have a VOM to check the plug...
Sounds like those two cylinders are not firing. Or not firing when there is compression. Check your plug wires and make sure they are not crossed....
Could a spacer be missing between the pump and the pulley? Original pump and pulley right?
could your crank pulley be on backwards?
The pin thats in there now is solid. So when you say a roll pin you mean the type that is hollow?
The old t18 has some major side movement even when it is in a gear. I removed the shift lever and it seems the pin/hole for the pin/keyway for...
I know the lining should be shorter on one shoe-but I don't see any holes for the rivits near the upper edge of the front shoe. Maybe you did...
The fuel line for the rear tank on mine has 2 lines coming out of the tank to the left and they go up to something by the tail light. Then one...
When you have a chance you might look at the valve springs when a valve is open to see if the spring is totaly colapsed. Maybe with a little more...
I think there is a way for your rig to run right with the stock dist. and points in it. But everything has to be right. You might want to make...
This Jeep has parts from everything. The title says 1968. All the bushings and linkage seems ok. When I changed the linkage on the clutch pedal to...
The clutch on this thing seems to work fine when cold. The trouble is after 5 -10 minutes of driving around the neighborhood it gets harder to...
If you can measure the bore of the wheel cylinder it will get you alot closer to what you need. Sometimes the small independant parts stores are...
I would make sure the lenth of the new dist. is the same as the old one. Also did you put a new dist. cap on with the new dist? A crack and a...
Separate names with a comma.