Base plate being flat stock = aftermarket.
I've blown out the gears a couple times, but have yet to split a case using an IH Scout 20 case that came out of a turbo diesel. Its got a fairly...
Mine are narrowed to 54" WMS, 4.75 Backspace, 10" rim and they still stick out a bit. 65.5 will have you out 5.75" farther than mine. Unless you...
Pics of the lever set up on mine. [img] [img]
Nope. You can't see it good in the other pics, but the bottom of the rack is hinged at the body and the top is pinned in with 5/16 latch type...
This isn't exactly mad fab skills, but rather a tiny PITA project I've been putting off. A while back I picked up some Gerry Cans to replace my...
Mine is PTO and like Grinsha's pic. The clutch fork was bent bad when I got it and I had to get a new one from Ramsey. My forks set screw had...
Yup, it's a Saginaw. The Muncie has the reverse shift link on the tailhousing, not the side cover.
Looks like the clutch lever is missing. Service parts are still available for your winch from Ramsey.
My vote: Caster. When you hit the brakes your brakes are fixed to the axle housing and trying to stop rolloing mass of the...
These guys devoloped the system for Holley. Best setup on the market and they can burn a prom for your ECM based on engine size, cam, etc.......
I didn't really notice it to be annoyingly loud after putting on the throttle body injection. TBI takes the fuel slosh problem out of the picture...
I think my one wire alternator was about $60 from a Carquest store. Bolted in the same mount as the old motorola.
You can get a plenum from K&N and use a MAF mount to go through the firewall, then hook a K&N filter on it. I didn't go with a high external...
Moser, very good products. I've used them many times for different projects. http://www.moserengineering.com/Pages/Axles/customalloy.html
It goes here. Unless it was replaced or fell out, it should be a square head with a safety wire hole in it.
I made a stainless plate with a small 90* bend at the bottom that bolts to the rear cross member. About 14 years later, still working:)
Myself and someone else I know had the C-clip(s) holding the center pin in snap off during brake throttle modulation (BTM). Later the pin then...
If I get a minute or two in the next few days I'll pull the top off and see if it's all intact inside, it looks like it's never been apart. I...
You still looking for one of these? Shipping would probably cost more than the replacement parts for yours. Anyone coming through Michigan, or...
Separate names with a comma.