If you're going to be in the Grand Junction area, shoot me a PM. I know of a few mild trails here.
I added a fuse panel to mine, but it does not have a solenoid. The ignition switch should not lose power to "ON" while moving switch to "START"....
Yes. If you rotate the forward axle too far, the pinion angle will no longer be parallel to the transfer case front output shaft angle. This is a...
Woops - missed that. (y)
Wow - just up the road from me...but wrong color for my CJ.
Hmmm...no engine bay photo. Can you tell if it's auto or manual?
The half cab helps balance the high hood IMO. Sorry, my garage is full.
That OHC engine was before it's time...maybe not the best... Jeep Tornado engine - Wikipedia And the T-89 is a good tranny... The Novak Guide to...
Photos would be nice! ;)
Complete with bumps & bruises...TRAIL READY!!!
Go postal?!!! You're all set. :cool:
In short, go with the D18 because it has the proper output offset for your rear axle. The D300 has a centered output, like a D20, that matches the...
Have you searched the site? This topic has been covered multiple times. I'm using a Speedhut gauge cluster and a Crown sending unit.
[IMG] I think most here have similar concerns. :)
In the case of Andrew's photo, the 44 represents number of ring gear teeth and the 9 represents the number of pinon teeth. 44 / 9 = 4.89
HOn3
What I think when I read this thread title...complete with castle nut and cotter pin! [IMG]
That looks just like the roll bar in my '71 RII...I think these will fit earlier models, too. (y)
Separate names with a comma.