Well I got it in over the weekend! It was a struggle though. I did mate the two halves together and put it on a piece of plywood and blocked the...
I posted a wanted ad here for a T15 and had many responses with both complete tranny's and parts. http://www.willystech.com/parts/board.shtml
I am putting my new-used T15 in this weekend. I don't have a tranny jack so I was thinking of putting the tranny in and bolting it into the bell....
I called down to Bronco grave yard and they don't have any. They had me call Crown Automotive and they don't have any either. I will give the guy...
I am still putting back together my T15 and D20 from the carnage a few weeks ago. While I had it on the bench I was going to replace the shift...
I think that I have learned that it is called a slip joint on the driveshaft. The slip yoke is part of the the transfer case. The slip yoke is...
I have always gotten quality parts from them. $$$ though.
Thanks, I guess that it's not a slip yoke.
Seems like a silly question but on the rear driveshaft does the short piece of the driveshaft go at the transfer case end or at the diff? Does it...
That's the idea I was trying to get across. I didn't think about having a center console though. From what I have read the angle, being parallel...
I want to put a harness type belt in but it requires a shoulder height mounting bar. I don't wan't to restrict access to the backseat because I...
I heard ther was a timing chain guide that was often the cause of failure. Any experience with this or fixes?
Why do you say that the 360 is a cigar butt? I have both a 304 and a 360 in the family. Oiling, cooling, ??
I am working on a '79 CJ7 that has the "death wobble".It seems like there is too much gain from the power steering. The pulley is 5.5" in diameter...
Thanks for your input. I guess I leave them there with a bit more confidence now.
My friend just bought a 79 cj7. It's mostly show and not much go. The guy he bought it from put 1.5" wheel spacers on the rear to even out the...
I have the same sidepipes on my cj. I didn't put any hangers on the mufflers. It is all supported by the header bolts. I have had them for about a...
Thanks, How did you keep it from spinning? I tried a C-clamp and it seems to work. But it is braced against the housing and I wasn't sure if...
It's hard to believe no one has run into this before.
4wd hardware has most of the wiper parts you need. Look in the 76-86 section they list pre-76 parts there too.
Separate names with a comma.