Thanks. Learned something new again!!
They are from a 85or 86 cj7.
Have a 75 CJ5. I found frt&rear Dana 44 wide tracs. Will it make much difference in the stability of the cj5?? Will it ride better?? Is it worth...
Thanks guys for all the helpful input. Found small spring clip that locks onto needle valve body housing wasn't latched into place. Thus reason...
I have a 360 in my cj5. It had a holley dual line. To much for this engine. Removed and put a 2 barrel intake and carb. Motorcraft carb, Autolite...
84 CJ8. Installed new Z bar, all clutch linkages because they were worn out. Clutch was extremely hard to push in. Nothing like i have felt...
Thanks for all of the help. Spindles are off. Now to replace the u-joints.
Thanks. You folks are great help and full of humor. Makes working on these jeeps much more fun, knowing others have had the same problems before....
84 CJ8. Need to remove frt axles to replace u-joints. Removed dust cover. Can't seem to get the spindle off so i can remove the axles??? Any help...
Thanks guys. Sounds like i have some thinking to do. Later.
Have an M170 tub,didn't have frame but bought complete cj5. Added 20" to frame. Thinking of adding 1/2 ton or 1 ton chevy axles or simply replace...
I can tell you guys are a barrel of fun. I asked the wrong question here. Pics will be later when i get off work in time with daylight left.
I purchased a 59 Willy's CJ 6 off Ebay. Had been sitting in a garage for 5yrs. Cleaned tank, carb, flushed fuel line. Cleaned points and reset....
Separate names with a comma.