Yes, my frame was boxed in the engine bay area. I drilled out the inside hole larger to fit sleeves I welded in to ensure the boxing did not...
Can't get the image to post for what ever reason... It can be seen on pg 17 of the Saginaw Power Steering page.
I mounted my steering gear outside the frame as well. I used a box off of a 1978~79 Ford F150/Bronco however. It is configured the same as the...
My winch is a Koenig model 100 and it does have a very wide drum with about a mile of cable on it:) It sits down below the bottom of the frame...
Here's a pic of my power steering set up. Due to the great big PTO winch sitting up front between my frame rails I couldn't use a typical Jeep...
Yeah, it looks a lot better than what I started with:)
I picked up a 4x8 sheet of 16ga diamond plate (or tread plate) for $67.66... replace all my floors with it. Way cheaper than replacement panels....
I am just using two engine stands. They are not high enough to spin it all the way around so I have to take it off to turn it all the way over....
Sweet!! I don't want one... I want both:p Right and left.
I've got a few parts and pieces from Classic Enterprise, but they don't have these braces unfortunately.
Help! Looking for replacements for the two triangle pieces at the front of the tub that support the floorboards. Mine are cracked all over the...
Separate names with a comma.