Thank you for the great advice! I am interested in building it myself. I just need to decide if I have the time to do it before it is used in my...
Thank you for the feedback! I called Spitfire and they said the rebuild would be at least $5K, and they said parts may be difficult to find. I...
Does anyone have any experience with a shop in Colorado along the front range that does a good job rebuilding the dauntless engine? Thanks in...
Does anyone know who made this top? I belive the doors are Meyers. But, the roofline is different than the typical Meyers cab. iCloud
Donny, thanks for the great information! Can I just move the carrier and gears from the wide track to the narrow track?
I am wondering if I can move a new gear set that is currently in a wide track Dana 30 from a later-model CJ over to a narrow track Dana 30 with...
Anyone else have any ideas on what the noise in the above video if from? Could it be the mechanical fuel pump or water pump? Both are new.
[ATTACH] Here’s a picture of mine after I replaced the gears and chain. You can see the two dots lined up. For me the hard part was getting the...
[MEDIA]. Hopefully, this link works for the video of the engine noise.
[ATTACH] Well, I replaced the distributor with a new HEI and also replaced the oil pump gears. It is running fine (other than the oil pump is...
Replaced timing set, oil pump gears, distributor, water pump, and fuel pump, but still have clatter from front end
I am a couple weeks out from replacing the oil pump and the distributor with an HEI. I’ll post when I am done as to whether it resolved the...
Thanks for the picture! It appears my cam matches yours, which means my distributor must have been remanufactured using a distributor body from a...
[ATTACH] I am still a little unclear on what the cam lobes should look like. It has three paired surfaces like one in the photo, each seperated...
I have a 68 dauntless, with engine stamp of 991503 and DPH. I have been chasing down a clattering noise coming from the distributor shaft at...
The noise was there before and after replacing the timing chain. I did not see any evidence of rubbing on the timing cover. There was a plastic...
The sound seems to be coming from much lower in the engine.
I have been restoring a late 60’s Dauntless V6. It has good compression on all cylinders and is tuned and running well. I also have a new timing...
I have a dana 27 powr-lok I purchased from another member a few years ago that I am getting ready to install. It came from a IH Scout. When I...
Thanks! I was worried it might be 3.77's
Separate names with a comma.