Its a 74 CJ5 and picked up the lift of craigslist so don't know the brand. As far as the shackle nuts I am going to double check that today...
So took the Jeep out today for the first ride since the complete rebuild. I picked up a pair of "4 in leaf springs" of CL and don't think they...
Thanks for the pic that is what I was seeing online....now with that confirmation I am assuming the I6 must not have been from a 74 since it does...
Thanks Tim for the help. Its odd I found pictures showing where it should be and I do not have the tapped hole in that location. I only have...
Yeah I realized once there was a hole it was some type of mechanical gauge didnt realize it had ether. Regardless no problem since I am going...
I am doing a complete rewire and went back to the stock speedo with temp/fuel gauge. The PO had an aftermarket temp gauge that has a copper wire...
Thanks! For the horn is that just the extra black wire that will need to ground for the horn switch? I cut my column down and in turn lost that...
huge help! got some switches on the way and done with the ignition/front/rear wiring. now the dash/gauges/and turn signal...running into a few...
Yep I found pn 276-1144 from radioshack somebody recommended. Shows its rated at 3A so might try to find a larger one when I am there. Next...
awesome diagram just what i needed....for the alt exciter to the harness did you use the original resistance wire or the standard 12 gauge white...
I am finally getting going on wiring up my 74 CJ5 with an EZ Wiring kit. I am a little confused with the ignition switch setup due to the wires...
I just put a glass tub on my 74CJ5 and was in the same situation. I ended up buying a used filler assembly from a YJ. When I got it I realized...
If you are just looking for more room and are on a budget I would suggest just cutting the column down. I was in the same position with a 74 and...
When I bought my 74 CJ5 nearly in parts it had an old rotten tub on it and at the time I was able to drive it up onto a trailer and the reverse...
Thanks although I didn't even get to the wiring except for mounting the fuse box. Apparently cutting the steering column, fabbing up seat...
I am about to tackle the install of my EZ Wiring harness this weekend and would like to see some shots of your engine bay with wiring to get a...
Thats a big help. If you can snap one at floor level closer that would be great but this might be enough for now. Thanks!
I am in the final stages of getting my 74 drivable and am drilling and mounting things to the firewall and was wondering if anyone had any good...
Thanks for the input...it turns out mine is not the collapsible. Its just the standard long bus style without tilt. I was hoping to get tilt but...
I am in the process of mounting my fiberglass tub and will be putting in the steering column this weekend. As everyone knows theres not much room...
Separate names with a comma.