Don't run a 2 barrel carb on a single barrel intake with adapter.
You should apply seam sealer after your first primer. You want the primer down in the joint as much as possible. But the sealer should be there...
Stout great job with your Jeep and documentation. I do have a suggestion for you. One advantage of using epoxy primer is the ability to spray the...
because a check valve works by letting air go in one direction only.
meant tire radius . . and yes I'm sure about that. I "is" a math whiz.
all you need is this, keep it with me all the time ( in my head ) ... rpms X tire diameter MPH= --------------- ........gear ratio X...
a simple plastic check valve in the hose somewhere solves the problem no matter what the vacuum source is.
they still will be marked on the back of the bearing as to the oversize amount.
If the shocks are not gas, they do not pull there self back out. So probably there was nothing wrong with your shocks and no body picked up on this.
Most automotive gauges work at 6V, not even 12V.
whereas things like this "have" happened, it certainly is not standard practice.
The bearings are usually marked whether they are .010 or .020 oversize. Its on the back of the bearing. If you think it hadn't been apart, then...
With everything you are doing to this block, you might as well replace the bearings too.
Separate names with a comma.