Anyone know how I can tell if this Powr Lock I bought is really a Dana 27 and not a 25? Heck I do not even know if they ever made a Powr Lock for...
Tried searching the forum and cannot find anything. I am looking for axle assembling specs for above. Need pinion depth, pinion preload, pinion...
Sorry if this has been covered already. i have searched the forum and stiil not clear. I am hoping to use r&p or complete carrier and r&p from...
I have a 1960 D27 axle housing that I am hoping to put a powerlock posi in and want to use 4:27 gears which I have a set from a D25. Will the D25...
Progress update. Installed the D18 Terra Low kit into a D20 case with large hole and the needed 1 1/4 shaft. Did not have to grind case at all,...
Looking to get one 16 inch rim so I can use a newer light truck (used) tire for a cheap spare for a 34-9.5-15. My question is are there...
Progress and results of Terra Low Kit in D18 Broke the gears in my D18 wheeling, I think low range shifter was not fully engaged, so upgrading to...
Looking to set Willy up with some good breathers for gas tank with non vented fuel cap. Filler neck has a 3/16 barb for vent hose, but wish to...
Yes I am running a Ford carb on a GM engine. Wondering if anyone else is doing the same and any ideas on tuning. I am using a Motorcraft 2100 2...
Just thought I would get back to everyone that helped with my hot start engine flooded problem results. V6 225 with Motorcraft 2100 2 bbl fit...
I need to replase a very worn steering shaft u joint. Unsure of year of shaft (lots o mods) it seems like early jeep. Anyway shaft is 3/4 inch...
Wondering if anyone can tell me the factory quantity of engine oil for a 65 225? Mine has a aftermarket adjustable dipstick and reads full with 5...
I am looking for a VIN plate for a 46 Willys cj2a. I purchased above with a title and it was previously titled and registerred but the vehicle...
I am having an intermitten carb problem on a 65 Buick V6 225 in a 46 Willys cj2a. Motor is internaly stock that I know of, has headers and I...
I am looking to swap the Holley Aluminum valve covers on my 1965 Buick V6 225 with original steel ones. I wish to do this because I am thinking...
Separate names with a comma.