Yer not plumbed backwards are ya? I have seen this
Found a mid '80s Full size GM wagon has a 2 groove vbelt drive pulley Also some older stuff, AMC and such, piggybacked the pollution pump off the...
the problem we found testin em in the wind tunnel was that the fan in front of radiator blocks air from going thru the radiator anywhere the fan...
I think the radiator might. I have looked em over too, and looked like some might!
BTW *******. I have a 3.73 carrier out of an offset 44 that I have no use for. Gears are Junk and the spiders are gone, but that stuff will...
Add some kind of lead replacement unless you know its got hardened seats. You will burn a valve in a F head, sooner or later. :eek: I run some...
Just a thought... Dunno if you added it to try to solve a cooling issue, or was it always there, but why are you running a pusher fan? That...
Yea, heard the Sanden types work fine as well. I guess I like the idea of an oil sump type compressor so ya dont need to inject oil Here is...
Anyone have any pros-cons on using a Chrysler RV-2 Compressor for an OBA setup? Just happen to have one on the shelf here! Looks to be a pretty...
Yea, Madizell has a point to be made. The challenge for me is getting over or thru obstacles. With only my skill and without maxin out the VISA...
Thomas built Jeep= 2 1967 Jeeps in Poor condition 2 years in the Garage 1 Small budget Add... a WELDED Dana44 rear, 25 Frt, F head, (slightly...
YEA! Weld it up an' ifn it breaks...get another one! If ya dont agree wit dat, I would suggest not welding yours up! Aint bit me yet...(Knocking...
he he he...Like the Buses!
Okay...My 2 cents.. There is only one reason you would weld a rear. PRICE! And we welded the rears in Stock cars for years, and they seemed to...
BTW W3srl... How do ya like the Lock-rite? Might be My next rear.
Hi ya Wes!! LOL! Jus do it!! We'll put another in if ya dont like it!
Hmmmmm... Didnt consider that yet. Everything there is new, coil, cap, rotor, wires, plugs, points, condenser. May have to look at the...
Hello all! Looking for some suggestions on YF carb woes! O-Hauled my YF (on a F134) and after much adjusting and jet and metering rod...
Separate names with a comma.