i really don't believe your v-6 or your tranny and transfer case care what's inside them when it come to the leaks. it has more to do with gravity...
is this what your looking for? http://www.jeepdoc.com/catalog/partframe.asp?id=1048
Here's a picture. like chuck said in front of motor mount, below alternator and above oil filter [img]
according to my fsm you have it correct :P .............good luck
Chris; if you think your motor is in fairly good condition and not all gunked up inside. I'd go get me 5 quarts of 5-30w oil and a new...
sparky; i was thinking [well you know ] if all he was looking for was a efi that it might bolt up to his block and heads. not to wasp...
one place to look would be at the 90's and 2000's firebird and camaro's they had the 3.8 efi with rear wheel drive. good luck and let us know what...
thank you :roll: i needed a reason for a few :beer: :beer: :beer: going to the refer now :D
what i did . hooked up a test light to the sending unit where the sending unit wire connects. if there is juice going to the sending unit from the...
that block is a 86-87 mostly turbo engines. probly the best rear wheel drive block to come from the factory in production cars.. you did good!!! 8)
one other, although not mechanical but important difference 71= AMC 66= Kaiser
on my 69 there are two on the right side and one on the left. there are a total a nime mounts for the tub.......................
here the link i have......... http://www.thejeep.com/manual.html#TSMLATE and by all means get the manual
here's what i have :P http://www.bearcreeksurvey.com/NOSRepro.htm
if it's a white steamy type of smoke could be a crack in a water jacket or maybe a bad seal on the intake manifould gasket. check oil to see if...
onething to consider is the gear ratios. d18 2.46 and a d20 2.03. also if you ever wanted to use an overdrive your out of luck with the...
yes sir! ok it's sunny high 70's...tops off the jeep...........going to go hop in and good cruisin now :P oh and did i mention have a few...
four low huh! ok here's some 2.52 first 2.43 low at 5mph = 30" 1695 rpm " 33" 1541...
here's some numbers for you to mull over; 63-77 m21 and m22 = 2.20 first gear 66-74 m20 = 2.52 first gear ok at 60mph in forth...
fsm; calls for 5/16 18 tpi x 5/8". star washers are used- torque 10-15 ftlbs
Separate names with a comma.