i flipped the ends on all three of our rock jeeps to the top.... actually quite easy. all i did was get a reamer with the same taper. reap out...
how about if i were to drill like a .5 or .75 hole for a harness... as in i am going to put a switch panel up there?? i am not worried abou...
Has anyone run wires through the roll bars and brought them out somewhere in the tube (through a hole) like to wire up a dome light or an over...
does anyone have an easy solution to extended brake lines that rub the tires....i have the articulation so i need the long lines but cant seem to...
does anyone know if it will even fit in a 64 flat fender??? this is my biggest concern thanks
has anyone put or know anything about putting a 302 out of a ford....Mustang,truck...i am thinking about doing the swap and am wandering if anyone...
where does the spacer go????? i dont see a spacer in the diagrams
forgot ok so i forgot some vital information. the problem is that i have no shimms on it, i can actually tap the race in past the axle flange....
i have a dana 44 under my 64 cj 3 and my problem is that i keep eating bearings. the end play in the axle shaft is way to much i know that. does...
Separate names with a comma.