I am tring to figure out what I should do for my fuel sending unit. Would the original work even though I have converted to 12V, (would the...
Jerry, I just installed mine, what do you need to see, and I'll get pics for you..
John, I had the similar situation to yours... Fresh rebuild, and a leak from the rear of the motor. It was the oil galley plug that was...
there was not any numbers casted in the drivers side of the case, or on the top. There were some letters stamped into the shifter piece... its...
Final update. The rod bears should have been .050 thick, but .020 was installed. I took the crank to the guy who built the motor, and he...
hind sight is always 20/20.... I should have built it myself. Im going to call that guy on monday, but i doubt that i will get any money back.
I have .02 bearing in it now... But i have to go get a good micrometer, then order the bearings... Its going to be fun, cause this is all new to...
Problem found... The rod bearings are too small. There is a ton of play on all of the rod bearings... I guess I get to learn how to replace...
what would be a good resource to use to rebuild the motor? Other than whats on the cj-3b page.
thanks Jim, i'll give a try tomorrow night.
CT, I have since changed the oil... I cant really run the motor for any extended period of time. I am right in the middle of the rebuild, no...
I will have to try that. I know it is coming from either #3 or #4 not sure which. What should I be looking for, the inner workings of a motor...
Update.. I replaced my oil pump finally, still low oil pressure, and a knock. Any ideas on what the problem could be? Im really at a loss....
The engine has been flooded several times due to carb problems which have been fixed. The fuel pump is new so i doubt it is leaking. After the...
I checked the oil pick up and it is tight and a gasket is there. But when I drailed the oil, there was a vey strong gas smell. Fresh oil and...
I spoke with a friend of mine, and he suggested that I replace the oil pump to go with the rebuild, which does make some sence.
The motor has 0 miles on it and maybe an hours worth of running. I did not do the rebuild, a local performance shop did the work. The only thing...
There is chatter and other knocking noises coming from the motor. The gague is fairly new, but by hearing the motor knock it kinda rules out the...
I finally got my m38a1 running again after sitting for about a year, but I noticed that I was getting very low oil pressure at idle(the needle...
Found them.. Archer Brothers had them. Now i just have to remove the uppers... Thanks agian for the info.
Separate names with a comma.