I'd call Walcks and tell them what you have. I'm sure they can help you out with what you need. The stock system is pretty good and actually low...
There are two different bench seats as well. My cj-6 has a more plain version as compaired to my Tuxedo Park which has an adjustable (driver side)...
All shade tree here. I used a sawzall to cut the blade and I cut the supports and blade guide attachments with a torch. The blade is now 6'. I...
That setup is not electric over hydraulic and is going to require a pump that runs off the motor. I found a Meyer E47 with a 7.5' blade off an...
After some head scratchin' I finally got it working. Had the solenoid wired wrong. monkeys
The solenoid will be the first thing I check in the morning.
I just upgraded to a new internally regulated alternator (three wire). Problem is I'm now having issues with my plow. I've got a e47 Meyers. When...
Ok, got it wired up and as a bonus it seems to be working. Except I gots some other issues now.
The more I look at this the more I get confused. Is the only change I need to make is a heavy gage wire (10) from the alt. to the starter, jump...
Thanks, I've been on the MAD sight, but seeing as they are trying to sell something I was wondering why I couldn't use the original wiring. Larger...
I've been going over searched threads for a couple of days now and haven't found what I'm looking for... I am looking at replacing my alternator...
Nothing, other than its messy. I did have mine leak and cause a real mess, but as far as fuction, they do do the job well.
That jeep in the pics is Empire Blue Poly. Same original color of my 5a. Its a metalic color (or was). Spruce Tip is darker. I would go with the...
The camera was left at the cabin last weekend, so no pics. I'll get some up if I can find my daughters camera.
I think it could fit with out modification, depending how thick the element is. Sounds interesting.
Just finished some repairs and some modifications to my "6". Talk about project creep, I think I fell victim. I started out wanting to replace...
What is involved in priming the oil pump? I've been following your thread as I've been doing the same project. Or to be more accurate, my T/C...
You could do the tie rod conversion. This puts the tie rods on top of the knuckle instead of on the bottom. You should be able to find more info...
If it will work for you. Its not too bad. Looks like the floor has been replaced in the front and rear areas. Depends on what your looking for....
Re: Single stick T/C stock in '65 CJ5? From what I can see here http://www.earlycj5.com/zoomer/Vehicle_Indentification.pdf it looks like that VIN...
Separate names with a comma.