If things go as planned - I'll be retiring the end of the year... maybe sooner depending on some peoples B.S. but that might cut into the fun and...
Got out and played a little in the shop. I'll try to take photos of the cowl conversion where we are putting the fuse box. B (neighbor who...
Yup - then look for another case - "just in case". Too bad your that far away, I've got several in the parts bin out in the shop.
Time for a bit of an update - was able to go out for about an hour and finished the fish plates and boxing for the front cross member. Finished...
Yippee - got the 'OK' from the Dr to start being able to do things in the shop again after my latest "Damn, I'm getting old and cut open AGAIN"...
Looking forward to see how you make out. I've thought about putting a jib inside the shop around the big table / mill area to help with things...
I've always gone with OXed and Locked... but that's just me :D. I yoke the rear a lot, front only in a few bad spots.
Hope you mean 230... 130 is pretty cool and the thermostat shouldn't have even opened by then. :cool:
I like flatties - the blue '49 3A is on a 5 frame. Been doing it for years.
Worked as welder too years ago - Magnum Metals, Craig CO. Seen several tanks 'blow' that had been 'sitting for years' - some diesel and some gas....
Separate names with a comma.