Like Piffy, I got a flex hose with two different sized ends. Got mine at NAPA.
[IMG] Not as cool as the ones shown from Montana, but here are mine.
This design is pretty much what I had hoped to someday accomplish. I am very glad to see that someone has it put together. My past experience...
The rear differential in my 3A is a 41. I have a Lockrite installed. Although I do drive it on the street, I do not have a top and thus I have...
I believe a hose runs from that pipe to the PCV valve on my right side valve cover. Unfortunately, my Jeep is not here at the house to check.
Jordan, I hope to know how well it works out in the next couple of weeks. I was trying to reduce the 2" column size. This will result in only a...
This is what I am hoping to use. This part has a 3/4" id hole in the bearing at each end. I am planning to weld a mounting plate to it that will...
Here are a few pictures of my sliders. They are predominately made of 1 1/2" square tubing with 1" diagonal braces. 1/8" plate. They are bolted...
I used a two hole, right side knuckle with a tie rod flip on my 3A. I have clearance on both sides at full turn. I used the taper and insert...
Well, time for a small update. My one piece tie arrived and I installed it today. I disconnected the tie rod that goes from the bellcrank to...
Sparky, I have been using 75-140 wt. synthetic lube. Thanks for the history on your oil experience and asking about the Richmond test. I will...
Thanks to all who have responded so far. I am using a Richmond, lockright locker 2110. It does have some slip to it. I will try to answer...
Hi all, I have a 1950 3A that had a richmond locker installed in it last year. Since the installation, steering has been extremely difficult....
Separate names with a comma.