Thanks, those seals look similar like what I'm removing. They definitely had the metal spring piece, and I don't think the ones from Kaiser...
...of the output yoke? if it's at all scrtched/grooved you will leak :( This has been discussed a lot here, do a search foe D18 AND seal AND...
...this should be? I assume it's 1.550 nominal? I'm using the Timken 473229 seal which is spec'ed for a shaft diameter of 1.562. Being a double...
Gotcha, apologies.
To clarify, I was asking specifically about the yokes, not the seals. Im already using the Timken 473229 seals.
There's a Timken double-lipped seal that's recommended over the omix replacements - Timken National 473229
I didn't find there's enough room for the felt with the two seals.
...still wasn’t clear to me though. If I go with 2 seals like the FM 473229 are you adding the second seal to replace the felt or are you putting...
Went to the parts house to get a seal, National 473229 they only had one. I ask the counter guy if he could cross the number over to anything...
Well, I haven't pulled mine out lately to check but I believe it's still double lipped. :rolleyes:
...where old, for a rear seal on a T-Case. Threads listed a National 473229 as a double lip seal. Is this seal still a double lip seal or is...
...yoke. This is a common update to reduce output shaft leaks. These can be used on both the front and rear output shafts. NATIONAL # 473229 Mike
Is there room for the drum with yoke to seat properly with 2 seals.?
...above: [IMG] The closed 450185 is about 0.5" thick, and the open 473229 is about 0.31" thick. I think I'm going to use two of the open...
...before a major brand name... Victor 49372 National 450185 National 473229 GM 15527579 SKF 15655 Spicer 34968 Timken 473229 AMC 8131669...
My notes indicate the Timken National 473229 applies to both input & output. This is a double lipped seal. Spec'd for 1.5625" shaft. I can't...
Do you have a washer under the nut?
...to put the rear output back together. Double sealed with 2 Timken 473229's is the only change I made. Put the parking brake back together,...
...trany and TC, especially on lower bolts, “right stuff” gasket maker on TC pan, double National 473229 seals on rear TC yoke. [img] [img] [img]
Just finished putting in the double seal (473229), and replaced the shims and used the Permatex copper spray, then replaced the pan gasket and oil...
Separate names with a comma.