Bolted the hood on and strapped it down. Rode once around the block. The old Herm power steering was good but the Saginaw was very smooth and...
Did the radiator clear the steering gear without any modification ?
It’s that time of the year again!! Time to roll Althea into the garage for the winter upgrades and maintenance. Here’s the list (more to be added...
I made a little progress today. Again, two steps forward, one step back. I got the rear backing plates on and mostly installed the front discs....
Thanks! Looking into an 11" drum swap for sure. I think Herm sells a full kit, did you go 11" on front and rear?
So yes this champion radiator is for a late 60's dauntless CJ5. It's technically not correct for my '71, but since I used Herm's Ford reverse...
The steering column and steering shaft is stock but highly modified, this is Herm the Overdrive Guy's reverse ford power steering gear set up....
Its been about 5 months since my last post and I have made some progress in the right direction. I finished all the fab work and installation of...
Your jeep looks great! Just a heads up, your power steering mount is the Buick 455 mount. That mount is has been mistakenly bought by many here...
I can personally say the mechanical pump and the Herm mount/Ford gear are VERY tight. I was not able to remove the fuel pump without removing the...
No, that’s not all. Going after the looseness in my steering. I took apart the drag link and tie rod. Found the steering gear is not tight on the...
While installing my Herm Ford Reverse steering box, I have noticed it is very close to my mechanical fuel pump for my Buick225. I am considering...
I have been working on installing my Herm Reverse Ford steering box on my CJ3B with a NT Dana 30. I ran into a problem with my drag link, but...
I changed to power steering at the same time. I used the Herm kit to keep the steering gear inside the engine compartment. I like the looks of...
Hey everyone, long time no update. I have gotten everything on the rolling chassis pretty much done. Really I'm stopped until I get a body, For...
Update from this weekend- I finished up the emergency brake and installed the companion flange on the T-case. That finishes up the T-case and the...
Well, after a lot of hemming and hawing, I have a solid plan. Gonna havta push out my planned trips in 2022, - need to allow funds to build up...
Lots of folks have the Herm kit with V6. But maybe not the 4.3 your using. Look for the topic “ post your power steering photos here” I looked...
Hello All, I am working on blending two cj5's. The frame is from a 1956 and I also have a 1955. I am installing a Chevy 4.3 v6 and power...
...choice for me anyway, as this way I can do a saginaw or herm steering conversion easier, will have hanging pedals for the brakes and hydraulic...
Separate names with a comma.