corner guards, smooth steel, 73 cj6.... where?

looking for smooth steel corner guards with no cutouts for my '73 CJ-6.

with dan duffy closing up his shop (http://offyourrockers.com/order.htm), i have only come across the warrior products..

http://www.warriorproducts.com/Catalog_By_Vehicle/Pre_1976_Jeep/Body_Armor/Jeep_Rear_Corners.html

is there any other vendors out there i should take a gander at?

thanks folks,

oak

 

I have seen that warror product with no cutouts at quadratec for my 73 cj5
Posted via Mobile Device

 

Try these out from metalcloak .... I had some custom ones made and you can cut to fit.
http://www.metalcloak.com/Jeep-CJ-5-and-CJ-7-Body-Armor-s/29.htm

 

doc... are you suggesting i go with the full quarters and trim back to where i want?

http://www.metalcloak.com/MetalCloak-CJ-5-Corner-Guards-p/2436.htm

mix in my labor, and the cost of the 'cloaks... i might as well get some stock bend them around a phone pole and beat them to match..

part of me like the metalcloak offerings (especially the overline fronts), but on the right rig...

not sure if a cj6 is the right rig...

 

place cut panel on corner with c clamps bend little by little adding c clamps as you go
till it turns out looking something like this I just used diamond plate

take your time and it will come out nice

 

http://

I had mine bent at a local metal fab. For $60. I think they are 3/16 thick and heavy.

 

did they cut them as well, or did you do the trimming to fit the corners, cutouts, etc..?

thanks... they look really nice..

oak

 

I cut them with a cut off wheel and trimmed to fit. Stainless bolts are sunk slightly into the steel. It was tough to get them tight to the body.